2400 BPS Internal Modem (250-3538)  Com Port Settings  Faxback Doc. # 5102

Set the port your modem uses with the SETUP_11.COM program on your MS-DOS/ 
GW-BASIC diskette.  As set at the factory, the 1100 FD assigns the RS-232C 
connector as the primary port (Com1) and the internal modem as the secondary 
port (Com2).  You can change this setting by following the instructions in 
the 1100 HD's USER'S GUIDE.

Run DeskMate by inserting your DeskMate 2 diskette and typing:

C:desk <ENTER>

Follow these steps to setup DeskMate to use the modem.

1. Press F10.

2. Highlight SETUP and press ENTER.

3. Highlight COMMUNICATIONS SETTINGS and press ENTER.

4. Press the down arrow until the underline flashes below the port assigned 
   to the modem (com2 default) and press the space bar.

5. Press the down arrow again to place the underline under MODEM next to
   CONNECTION.  Press the space bar.

6. Press the down arrow to highlight HAYES in the Modems window.  Press 
   ENTER.  Then, press ESC twice to return to the desktop.

(abo-07/28/93)