Range Doubler  (220-0215)   Controls and Functions     Faxback Doc. # 6538
Multitester

              Scales - Three-color scale with mirror, green scale for ohms
                       readings, red scale for ACV readings and black
                       scale for DCV, DCA, and dB readings.

   Zero-Adjust Screw - Use to set the pointer exactly over the 0 at the
                       left side of the AC/DC scale for ACV, DCV, DCA, and
                       DB measurements.

 Ohms-Adjust Control - Use to bring the pointer to 0 on the OHMS scale
                       when measuring resistance on the OHMS range.

Range-Doubler Switch - Use to divide the range setting by two if the meter
                       reading is not in the upper half of the scale
                       during the initial measurement.

           -COM Jack - Plug in the black test lead here for all
                       measurements.  Do not connect this jack to any
                       source of more than 500 volts with respect to earth
                       ground.

      +V-Ohms-A Jack - Plug in the red lead here for all measurements,
                       except DC voltage measurements above 250 volts and
                       DC current measurements above 500 mA.  The maximum
                       AC voltage measured here is 1000 VAC.

      +1000V DC Jack - Plug in the red lead here when measuring DC voltage
                       between 250 and 1000 volts.

        +10A DC Jack - Plug in the red lead here only when measuring DC
                       current of 500 mA to 10A.

INCLUDED ACCESSORIES

Spare Fuse - Cat. No. 270-1271 - 250V, 0.5A, Stored inside the tester.

Banana Plug Style Test Leads - Cat. No. 278-704.

(BR/all-07/11/94)