TAD-514  (430-0752)          Remote Code               Faxback Doc. # 6957

Using Remote Control Command

Follow these steps to use remote commands.

1.  Dial your phone number.

2.  Wait for the TAD to answer, when the TAD plays the OGM, enter your
    security code.  The TAD responds with a beep.

Note:  If the TAD has no recorded messages, it does not answer until the
fourth ring (toll saver).  If it has messages, it answers on the second
or third ring.

3.  After the beep, enter a remote command by pressing the number for the
    desired function.  See "Remote Control Command Descriptions."

After each function, the TAD sounds the command prompt (two short beeps).
You can then hang up the phone or enter another command within 12
seconds.

Remote Control Command Descriptions

Play - Press 1 to play incoming messages.  The tape rewinds and plays
all the messages.  After the last message, two beeps sound.  You can
either save, erase or replay the messages.

Save - To save messages, simple hang up the handset.

Erase - Press 6 after the TAD plays the last message and sounds two
beeps.  The TAd responds with two more beeps and disconnects New
messages record over the old messages.

Fast Forward - Press 9 to fast forward through the messages during
playback.  To resume playback, press 8.  If the tape reaches the end
of the messages, the TAD sounds two beeps.  Press 1 to replay the
messages.

Rewind - Press 7 to rewind the tape during playback.  To resume
playback, press 8.  If the tape has rewound to the beginning, the
TAD beeps and plays the messages again.

Stop - Press 8 to stop play or to stop rewind/fast forward.  The TAD
stops and beeps twice.  To resume play, and beeps twice.  To resume
play, press 1.  The tape rewinds and plays all the messages.

Change OUT-GOING MESSAGE - Press 3 to record a new OUT-GOING MESSAGE.
The TAD beeps.  After the beeps record your new OUT-GOING MESSAGE.
When you finish, press 3 again to stop recording. A beep sounds and
the new OUT-GOING MESSAGE plays so you can check it.

Note:  In order to change the OUT-GOING MESSAGE by remote operation,
       you must first erase all messages.  Make sure all messages.
       Make sure you have listened to any messages, enter the erase
       command (6), and then change the OUT-GOING MESSAGE.

Recover (Retrieve) - Press 4 to recover messages if you pressed 6
to set the TAD to record over the old messages but now want to
recover them.

Answer Off - Press 5 to set the TAD to not answer calls.  The TAD
beeps to confirm that the TAD is off.

(SMM/smc-05/18/94)