4-Channel Mixer  (320-1105)       Features              Faxback Doc. # 8807

The REALISTIC 4-Channel Stereo Microphone Mixer is a sophisticated center
for all your mixing needs-recording live performances, playback and more.

This unit is ruggedly constructed and should give you years of performance
in home or professional use, if you follow the operation and care
instructions in this manual.

The mixer is a very versatile unit - The more you use it, the more uses
                                     you will find.
FEATURES INCLUDE:

*  Four inputs for both MIC and LINE - For up to 4 stereo or 8 mono inputs.

*  Switchable stereo/mono output.

*  Glide-Path sliding level controls.

*  Battery operation - You can operate your Mixer with portable equipment,
   anywhere.

FRONT PANEL:

BATTERY Indicator LED:.....Lights to indicate battery is in good condition.

POWER Switch:...................................Turns the Mixer ON and OFF.

MODE Switch:................................Sets output for STEREO or MONO.

Fader Controls:..............Increases or decreases the level of the signal
                           connected to the corresponding input jack-either
                                                               Mic or Line.

REAR PANEL AND CONNECTIONS

BATTERY TEST

Button:..........................Press to check battery condition.  If the
                                     battery is OK, the front panel BATTERY
                                                            LED will light.

OUTPUT Jacks:..........................Use shielded audio cables to connect
                                  between these jacks and the MIC inputs on
                                  your PA system or tape Deck.  If your PA/
                                   Tape Deck is monaural, use only one jack
                                      and set the front panel MODE to MONO.

MIC Jacks:...........................Connect Microphone(s) here. For stereo,
                                      follow the L and R marking below each
                                      jack: channels 1 and/or 3 for Left, 2
                                                        and/or 4 for Right.

LINE Jacks:.......................Connect the output from Tape Deck or other
                                  high level signal source.  Follow the L/R
                                                        marking for stereo.

NOTE: When both LINE and MIC inputs are connected to the same channel, the
      two signals are mixed.  To control the balance of two signals 
      connected to the same channel, you must be able to adjust the input
      levels.

GND Screw:..........Connect to your PA System's Ground screw to prevent hum.

(smc-03/03/94)