Remote Control  (490-0850)  Setting the Security Code   Faxback Doc. # 8952
Alarm System

The security code helps eliminate false triggering by similar systems.  To
set the security code, do the following:

 1.  Open the control module's code compartment by pressing down and
     sliding the cover in the direction of the arrow.

 2.  Set the dip switches, located in the control module, to any +, O, and
     - combination.

 Notes:  Do not set all the switches to the same position.
         The diagram on the top of the control module is only an example
         of a setting.  You can set the switches to any position as long
         as you do not set them all to the same position.

 3.  Remove the screw from the back of the remote arm/disarm transmitter
     and lift off the top cabinet of the transmitter.

 4.  Set the dip switches to the same combination you used for the control
     module.

 5.  Replace the top cabinet of the transmitter and secure it using the
     screw.

(SMC/jlc-03/22/94)